Key embossing devices are used to emboss smaller quantities.
With this device, most key shapes can easily be attached to the embossing slider with a clamp. This clamp is vertically adjustable and can be latched (left screw). After the key was brought into embossing position with the slider, the embossing wheel above can be set to the desired number.
With a slight blow of the hand on the protected embossing head, this number is stamped in (no impact tools required).There is a knurled wheel on the front of the device with a latch. By turning this wheel into the next notch, you immediately reach the position for the next character. The notches are aligned to the number height and allow the maximum use of the embossing surface.
The sign embossing device of this series has the same functions. Small signs can be fixed in this device. The embossing surface has a max. size of 50 x 50 mm. With both devices, the embossing wheel is engraved with a max. 40 characters. Standard: 0-9, A-Z, dot, comma, hyphen, slash. The number height can be freely selected from 1-4 mm.